weemote X – Channel Changing Options – Manual Correction

On page 18 of the weemote® X Reference Guide covering the options for setting the Channel Changing settings, an option step was omitted from the manual. This step is to clear any of the channel changing options you may have previously set.

Please find below a corrected update to this section of the manual.

  1. Press and hold down the “C” button for about 3 seconds until the LED light turns on solid green. Then, release the button.
  2. Press and release the “A” button. The LED light will blink and turn on solid green.

A. To insert the enter signal, press and release the favorite #1 button.

B. To insert the select signal, press and release the favorite #2 button.

C. To insert one leading zero, press and release the favorite #3 button. For example, channel 7 will be sent as 007.

D. To insert two leading zeros, press and release the favorite #4 button. For example, channel 7 will be sent as 0007.

E. To clear any of the settings you may have made above, press and release the favorite #5 button.

Whichever option is set above, the LED light will blink three times green to confirm it has been set.

weemote X – Channel Up/Down Option, Version R10

Reference Page 13 of the weemote® X Reference Guide. Please note that when setting the weemote’s channel up/down option to the favorites only mode (channels 6-10), you should make sure before setting that option to have programmed favorite channels 6-10 first. If you set this option first before programming the favorite channels 6-10, the weemote® may stop working depending on other program settings.

weemote® X Correction to Learning on the MUTE button

If you are trying to learn special signals on the MUTE button as described on Page 10 of the reference guide, please disregard those steps and use the steps outlined below.

  1. Press and hold down the “B” button until the LED light turns on solid green, then release the “B” button.
  2. Press and release the “100” down in the program area – the LED light will blink from green to orange
  3. Press and release the “Mute” button – the LED light will blink orange
  4. With the existing remote pointed towards the weemote, press and release the button you want to learn. If learned successfully, the LED will blink twice Orange and then go back on solid orange
  5. With the existing remote pointed towards the weemote, press and release the same button you want to learn again (2nd time). If learned successfully, the LED will blink three times Orange and then go back on solid green
  6. Press and release the “B” button to exit program mode. The LED light will blink three times green and then go out to confirm you have exited the program mode.

Note if you are having problems with steps 4-5, i.e. the light is going RED, you will need to adjust distances between the remote’s (try closer in the range of .5-1″ or farther out at 1.5-2.5″) and trying a different lighting environment. Also, make sure the batteries in both units are in good condition. Once you find the right conditions, we also recommend you repeat all the steps again to ensure the signal has been fully learned properly.

weemote X R13 Power Button Learning

There is an known issue with weemote® X version R13 models where the learning function is not working properly on the Power button.

With this version, you can’t learn directly onto the Power button without first entering an embedded code into the unit.

For example if you want to learn the TV Power Signal.

  1. Enter any random TV code in to the unit, i.e. code 10 as described on Page 6 of the weemote X Setup Guide.
  2. Learn the Power signal from your existing remote to the weemote X as described on Page 6 of the weemote X Reference Guide.

Note that all other buttons can be learned directly without taking this additional step.